SHARC Instructions:
The two interior stickers are printed on white vinyl, and the exterior is all clear.  As would be a problem with the original application, the "no access" sticker deep inside is too hard to place right without taking the vehicle apart.  You should completely disassemble the SHARC prior to starting to put the stickers on.  This will allow you to clean it better anyway. Cut out the "no access" and radar screen and line each edge with a black Sharpie; this prevents the very fine white edge from showing after application.  It doesn't matter much with the SHARD, since the edges of those two stickers are too hard to see anyway, as they sit in recessed areas of the cockpit.  Once those two are on, put the SHARC back together.  The remaining stickers are just cut and apply.  The only really noticeable difference between my stickers and the originals is that the "GI JOE" logo is in black on mine.  I do not make it white because (A) I don't print in white and (B) the SHARC is white, and you can't see it when it is white.