Skystriker Instructions:
You will notice in the pictures above that I have solved the dilemma of application of the pinstripes around the cockpit.  Particularly as a kids, did this ever go right?  God, what were they thinking when they made that intricate layout and expected an excited kid to have the patience to put those three stickers on right?  I made the cockpit pinstripes all one sticker.  It makes it much easier to apply, and you have no breaks in the sticker.  I apply that sticker first, because you have to apply the other stickers below it.  Put them on first and then the cockpit and you might discover it comes down too close (or over) the already laid down stickers.  Cut out the pinstripes exactly on the edge of the printed surface, or even slightly in from them.  Leave the backer on and test them.  If they look good, peel back just a section of the backer and cut it away.  With the tails still having the backer on, you don't have to worry about them sticking to the wings and such.  when you have the front applied, peel off the end of the backer (the tail of the stripe) and smooth it down as you want it.  Repeat with other side.  The only other than I recommend is coating the wing "red, white and blue" stripes with packing tape.  The reason being is that even with the originals, the opening and closing of the wings will destroy the ends.  Just prevent this by giving them a nice hard laminate.  Other than that, you can pretty much cut, peel and apply the rest of the labels while just following the blueprints for placement.